Fuel lines

[Ont240]

Take this into consideration is you are not using metal lines. If you have a flex section, use the EFI spec hose and proper EFI hose clamps not gear clamps. The ones that Nissan uses on the injector hose. Full circle and smooth!

image.jpg
https://www.motortrend.com/how-to/17...ar-or-hot-rod/

[Dr.Diesel]

Good tip Ont240, I agree with you. When I did my 240Z build, I used fuel injection hose and fuel injection clamps for the fuel system even though I was using a 3 psi carbureted system. I also used as much steel fuel line as possible throughout the route to the carburetors to keep the use of hose lengths to a minimum. For those interested, fuel injection hose and fuel injection clamps are readily available at your local Napa store.